This is where we write down what we learn on the shop floor and in customer conversations: which material actually survives your temperature, which one is the trap, what tolerance is realistic on a 200 mm PEEK ring, and what we need from you to quote a non-metallic part accurately.

Everything here is written for buyers and design engineers, not for material scientists. Where a number is quoted it is a typical value for a common commercial grade — the grade datasheet always governs.

How to use this section

If your question is about a specific material, each material page carries a full selection guide in ten sections — properties, machining notes, stock forms, fit and not-fit lists and an FAQ. Browse them under Materials. Everything below is listed newest first.

CNC Machining or Injection Moulding? Where the Break-Even Sits

Tooling cost, piece price and change risk decide between machining and moulding. The break-even usually falls between 200 and 500 parts — here is how to find …

POM vs Nylon vs UHMWPE: Which Wear Plastic?

POM, nylon and UHMWPE are the three plastics most wear parts are machined from. Where each one wins on moisture, abrasion, impact and creep, and how to choose.

Silicone vs EPDM vs NBR vs Polyurethane: Which Rubber for Your Seal?

Silicone, EPDM, NBR and polyurethane all feel like rubber but fail differently. Choose one by temperature, chemical and abrasion, with a comparison table.

PTFE vs PEEK vs POM: Which Engineering Plastic Should You Specify?

PTFE, PEEK and POM look similar on a drawing but behave nothing alike in service. A practical comparison of temperature, chemical resistance, wear, creep and …

Custom Parts Buyer FAQ

Answers to the questions buyers ask before ordering custom PTFE, PEEK, POM, nylon, rubber, graphite and ceramic parts from China — minimum order quantity, …

CNC Machining Processes & Tolerances for Plastics

How we turn, mill, drill, thread, saw and anneal non-metallic parts — what tolerance is realistic, which processes suit which material, and how to design a part …

Designing Plastic Parts for CNC Machining: 8 Rules That Cut Cost

Eight design decisions that decide whether a machined plastic, rubber or composite part is straightforward or expensive — tolerance placement, wall thickness, …

Material Selection Guide

Compare PTFE, PEEK, POM, nylon, PVC, UHMWPE, silicone, EPDM, NBR, polyurethane, graphite, ceramics, carbon fibre and FRP on temperature, chemical resistance, …

How to Send a Drawing That Gets an Accurate Quote First Time

What to include in an enquiry for custom non-metallic machined parts — drawing requirements, material and grade, tolerance, quantity, operating conditions and …