Parts
Generic non-metallic parts — fasteners, gaskets, gears, bushings, rollers and insulating components — compared across every material we machine, with links to the material-specific versions of each part.
Seals & Gaskets
How to choose the material for a non-metallic seal, gasket or O-ring — PTFE, silicone, EPDM, NBR and polyurethane compared on temperature, chemical resistance, compression set and creep.
1 parts →Gears & Sprockets
Material selection for non-metallic gears, sprockets and timing pulleys — tooth strength, wear, shock load, moisture movement and temperature limits for POM, nylon, PEEK and composite grades.
1 parts →Bushings & Bearings
Choosing the material for plain bushings, sleeve bearings and thrust washers that run without lubrication — load capacity, wear rate, creep and dimensional stability across POM, PEEK, nylon, PTFE and polyurethane.
1 parts →Insulating Parts
Material selection for electrically insulating spacers, standoffs, barriers and mounts — dielectric strength, tracking resistance, thermal limits and machinability across PEEK, PVC, FRP/G10, ceramic and graphite.
1 parts →Rollers & Wheels
Choosing the material for non-metallic conveyor rollers, guide wheels and drive rollers — grip and friction, abrasion resistance, load capacity, chemical exposure and temperature limits.
1 parts →Custom Components
Non-metallic fasteners, screws, nuts, washers, spacers and one-off machined parts — where plastic fasteners make sense, which material to use, and the tolerances and thread forms we can hold.
1 parts →A non-metallic part is usually specified in two steps. First you decide what the part is — a screw, a gasket, a gear, a bushing — and then you decide what it is made from. These two questions pull in different directions, so we keep the answers in two places.
This section answers the first question. Each page here takes one generic part type and compares how it behaves in every material we machine: where PTFE seals better than EPDM, where POM beats PEEK on cost, where a nylon gear absorbs shock that a PEEK gear would crack under, and where a material should simply be ruled out. Use these pages to shortlist a material.
The material pages answer the second question. Once you know which material you want, the Materials section carries the same part types in that specific material, with the grade data, the properties that matter and the part-specific detail — a PTFE gasket, a PEEK gear, a nylon sprocket. Every generic page below links straight to those specific versions.
How the two sections fit together
| You are asking… | Start here |
|---|---|
| “What material should a gasket be?” | Seals & Gaskets |
| “What should a dry-running gear be made from?” | Gears & Sprockets |
| “What do I make a wear bushing from?” | Bushings & Bearings |
| “What insulator survives 200 °C?” | Insulating Parts |
| “What roller grips and resists chemicals?” | Rollers & Wheels |
| “Do you make non-metallic screws, nuts and washers?” | Custom Components |
| “Show me everything available in PTFE” | PTFE material page |
| “Compare all fourteen materials” | Material selection guide |
If you already know the material, skip this section and go straight to Materials. If you know the part but not the material, you are in the right place — send us the drawing with the operating temperature and the medium, and we will recommend a grade rather than quote the cheapest one on the shelf.