Bushings & Bearings
Choosing the material for plain bushings, sleeve bearings and thrust washers that run without lubrication — load capacity, wear rate, creep and dimensional stability across POM, PEEK, nylon, PTFE and polyurethane.
Non-Metallic Bushings & Bearings We Manufacture
A non-metallic bushing earns its place where oil and grease cannot go: food machinery, clean rooms, semiconductor tools, water and chemical pumps, and any machine where a lubrication schedule is a liability. The material choice then follows from what dominates the application.
POM is the workhorse for a light-to-medium load bushing on a steel shaft. It is stiff, machines to a press fit that stays put, has a low friction coefficient and is dimensionally stable. Above 100 °C or in strong acids it is the wrong choice.
PEEK is where the load and the temperature are both real. It carries a higher PV limit than POM, survives steam and cleaning regimes, and wears far more slowly under pressure. The reason to specify it is temperature, load or cleanliness — not preference.
Nylon brings impact tolerance and a slightly better damping behaviour, at the cost of swelling with humidity. In a bushing a few tenths matter, so a nylon bushing must be dimensioned for the moisture it will actually see, or given clearance to cover it.
PTFE has the lowest friction of any common plastic, which makes it excellent for a lightly loaded sliding contact and poor for a loaded one: it creeps, so a press fit relaxes and a bushing under sustained force deforms. Where PTFE must carry load, use a filled grade.
Polyurethane is the choice for a bushing that has to shrug off abrasion, slurry or grit — it outwears rubber several times and tolerates a dirty environment that would destroy the plastics above.
The three numbers that decide it: load (MPa) × surface speed (m/min) gives the PV the material must survive; the continuous temperature rules out the cheap options; and the shaft material and finish set how much wear the plastic will take rather than give.
Material-specific versions, with grade data and part detail:
POM bushings · PEEK bushings · Nylon bushings · PTFE parts · polyurethane parts · compare all materials
Send the bore, the shaft diameter and hardness, the load, the speed and the temperature and we will recommend a material and a clearance rather than just quote the drawing.