Seals & Gaskets

How to choose the material for a non-metallic seal, gasket or O-ring — PTFE, silicone, EPDM, NBR and polyurethane compared on temperature, chemical resistance, compression set and creep.

Non-Metallic Seals & Gaskets We Manufacture

A gasket is a material decision before it is a machining decision. The geometry is usually simple; what decides whether the seal survives is how the material behaves against the medium, the temperature and the compression it has to hold.

The two families behave differently, and mixing them up is the most common mistake we see:

Soft elastomers — silicone, EPDM, NBR, polyurethane. These seal by deforming, so they tolerate a rougher flange and a looser tolerance, and they hold compression across vibration. Their limits are temperature and chemistry: EPDM is destroyed by hydrocarbon oils, NBR is destroyed by ozone and ketones, silicone tears easily and swells in many fuels, and polyurethane hydrolyses in hot wet service.

Rigid plastics — PTFE, POM, PEEK. These seal by being compressed into a groove or pressed against a seat, so the sealing face needs a better finish and the housing needs real clamping force. In exchange they cover the chemistry PTFE handles almost everything and the temperature PEEK handles steam and autoclaving. The trap is creep: a PTFE gasket under permanent load loses sealing force over time, which is why loaded PTFE seals use a filled grade (glass, carbon, bronze) rather than virgin PTFE.

Which way to go, in practice:

  • Aggressive chemicals across the whole pH range → PTFE, filled if it carries pressure
  • Hot water, steam, weather, outdoor → EPDM or silicone (PEEK above 150 °C)
  • Oils, fuels and hydraulic fluid → NBR, or PTFE where the temperature is high
  • Food and pharmaceutical contact → silicone or PTFE in an FDA / USP Class VI grade
  • Abrasion plus sealing → polyurethane, which outwears rubber several times over

Every one of these materials has a full selection guide with typical values and an FAQ:

PTFE · Silicone · EPDM · NBR · Polyurethane · PEEK · all materials compared

Machinable in a day, no tooling charge. Send the drawing with the medium and the operating temperature and we will confirm the grade before quoting.