Rollers & Wheels
Choosing the material for non-metallic conveyor rollers, guide wheels and drive rollers — grip and friction, abrasion resistance, load capacity, chemical exposure and temperature limits.
Non-Metallic Rollers & Wheels We Manufacture
A roller or a wheel is asked to do two jobs that often conflict: grip the surface it drives, and survive the environment it drives through. The material is decided by which of the two dominates.
Polyurethane is the default for a grippy, abrasion-resistant roller. It outwears rubber several times over, holds a machined profile cleanly, and can be supplied in a range of hardnesses, which lets you tune grip against deformation. Its limits are hot wet service, where it hydrolyses, and roughly 80–90 °C.
Nylon makes a light, quiet, impact-tolerant wheel — guide wheels, idlers, curtain rollers, small castors. It brings the same moisture caveat as any nylon part: it grows with humidity, so a wheel that must stay round needs its condition specified or a material that does not move.
POM is the precision option where the wheel is really a bearing: low friction, dimensional stability, tight tolerance, good fatigue life. Choose it when the rolling action matters more than the grip.
PEEK takes over when temperature, steam or load eliminates the others — it keeps strength past 250 °C and resists wear under pressure. Specify it for a reason, because the cost difference is large.
Rubber — EPDM, NBR, silicone — covers the softest end: rollers that must conform to an uneven surface, seal against it, or where the surface is delicate and cannot be marked by a harder material.
UHMWPE is worth naming separately because it is the best sliding material in the list — the lowest friction and the highest abrasion resistance among the common plastics — which makes it the standard answer for wear strips, guide rails and chute liners that the rollers run against.
The three questions that settle it:
- Does the wheel drive, or does it just roll? Driving needs grip — polyurethane or rubber. Rolling wants low friction — POM, UHMWPE.
- What is it running through? Slurry, grit and chemicals move you to polyurethane or UHMWPE. Steam and heat move you up to PEEK.
- How is the surface finish produced? A machined solid steel or aluminium core with a machined plastic tyre is normal; a fully plastic wheel is cheaper and lighter but deflects more under load.
Material-specific versions, with grade data:
Polyurethane parts · POM parts · Nylon parts · UHMWPE parts · all materials compared
Send the wheel diameter, the load, the surface it runs on and the environment and we will recommend a material and a hardness before quoting.