Custom Components

Non-metallic fasteners, screws, nuts, washers, spacers and one-off machined parts — where plastic fasteners make sense, which material to use, and the tolerances and thread forms we can hold.

Non-Metallic Custom Components We Manufacture

Metal fasteners bring three things to a machine that are sometimes exactly what you do not want: electrical conductivity, thermal conductivity, and corrosion that grows into the joint. A non-metallic screw, nut or washer removes all three at once, which is why these parts show up in electrical panels, plating and pickling lines, chemical plant, MRI rooms and food equipment.

Where plastic fasteners work well

  • Electrical isolation — a nylon or PEEK screw in a terminal or a mounting block
  • Corrosion immunity — PTFE or PVC in acid, brine and pickling environments
  • Low clamping force needed — covers, guards, labels, sensor brackets
  • Non-marking and non-magnetic — optics, wafer handling, delicate surfaces
  • Thermal isolation — a PEEK or FRP washer between a hot part and a cold one

Where they do not

A plastic screw does not replace a steel screw in a structural joint. Plastics are far less stiff, they creep under sustained preload, and they are far more sensitive to temperature. As a rule, a plastic fastener is right for light duty, isolation and corrosion — and wrong where the joint has to stay tight under load for years. Where a joint must both hold and insulate, the usual answer is a steel fastener with a non-metallic insulating bushing and washer, which is a bushing and insulating part job rather than a fastener job.

Material selection in one line each

Material Use it for Avoid
Nylon (PA66) General electrical fasteners, nuts, washers — tough and cheap High humidity with tight tolerance; strong acids
POM Precision spacers, nuts and screws needing stability Above 100 °C; strong acids
PEEK High temperature, steam, clean rooms, medical Cost, where nothing above 100 °C is involved
PTFE Chemical and food contact, low friction Load-bearing joints — it creeps
PVC Cheap electrical insulation, low temperature Hot water and steam
FRP / G10 Structural insulating washers and plates Where impact loading dominates

Threads and tolerance

We cut metric and imperial threads, including fine pitches, and can hold ±0.05 mm as routine and ±0.01 mm on POM, PEEK and PTFE. A plastic thread should be treated differently from a metal one: it is more tolerant of a slightly loose fit and far less tolerant of repeated assembly, so specify a thread insert or a coarser pitch where the fastener will be opened and closed often.

One-off parts

The same section covers anything that is not a catalogue item: a bracket, a manifold block, a custom spacer, a jig, a replacement for a corroded metal part. No tooling charge on machined parts, and single pieces are fine.

Material-specific versions, with grade data:

PTFE parts · PEEK parts · POM parts · Nylon parts · PVC parts · compare all materials

Send your drawing, the thread or fit, the temperature and the medium, and we will confirm the material and quote within 48 hours.