Laser Cutting

ORRO Manufacturing Co., Ltd. laser-cuts non-metallic sheet into flat parts — gaskets, shims, washers, pads and masks — with clean edges and no tooling cost. Laser cutting is the fastest route to flat PTFE, silicone, rubber and composite parts, and it handles both one-offs and repeating production.

Materials We Cut

  • PTFE sheet — chemically inert gaskets and sealing rings
  • Silicone and rubber sheet — FDA silicone, EPDM and NBR gaskets
  • Cork and fibre sheet — sealing and damping washers
  • Composites (FRP/CFRP) — flat structural panels and covers
  • Films and foams — spacers, masks and protective pads

Specifications

  • Sheet thickness: 0.5–25 mm depending on material
  • Tolerance: ±0.1 mm typical
  • Edge: clean, sealed edge on most materials
  • Max sheet size: up to 1200 x 2400 mm
  • Lead time: 3–7 days for most parts

Cutting Parameters

Parameter Typical value
Laser power 100 – 400 W
Cutting speed 500 – 3,000 mm/min
Kerf width 0.1 – 0.3 mm
Assist gas Compressed air or nitrogen
Focal length 2.5 – 5 in
Sheet thickness 0.5 – 25 mm
Achievable tolerance ±0.1 mm typical
Edge quality Clean, sealed edge on most materials
Min hole diameter ≈ 1× sheet thickness

Applications

  • Gaskets and seals — flange gaskets, O-ring alternatives and custom profiles
  • Shims and washers — precision thickness spacers
  • Insulating parts — dielectric pads and barriers
  • Masks and covers — protective and masking components

Case Studies

FDA silicone gaskets, 1.5 mm sheet — a food-equipment customer needed 20,000 FDA silicone gaskets at ±0.1 mm, with no tooling budget. We laser-cut them from 1.5 mm platinum-cured silicone sheet, delivering the full quantity over 2 weeks with no mold cost and clean, sealed edges.

PTFE flange gaskets, DN80 — a chemical plant needed 3,000 PTFE gaskets in DN80 with bolt-hole patterns to ±0.1 mm. We laser-cut them from 2 mm skived PTFE sheet and delivered in 10 days with no tooling cost and clean, sealed edges.

Request a Quote